| Line No. | Header Row | Instruction | |
| 1 |
|
SAFETY
Gloves and ear plugs are to be worn throughout this operation.
Be careful of pinch points. Keep fingers clear at all times when the machine is operating.
| Edit Delete |
| 2 |
|
SETUP & PREPARATION
- Ensure the machine configuration and setup is complete as per the Setter Training Manual.
- Daily Maintenance
- Physical Tooling is correct
- Correct tool is selected in the machine config
- Wire thickness is set in the machine config
- Adjust the overbends by performing a 90/20 setup.
Ensure the correct wire has been issued by validating GRN buff tag against the route card.
On the production system log the time as "Setting."
Load the Part Recipe found in the location "part recipe location" and prepare a First-Off sample.
Once the first-off is correct, on the production system end the "Setting"downtime and enter the job number and operation to start the job.
Enter the first-off inspection results in the production system.
| Edit Delete |
| 3 |
|
QUALITY CHECKS
The following checks should be performed:
- Do not force the part into the checking fixture.
- When placed in checking fixture, part shall fit flat in the slots between the pins.
- All angles and rotation must be correct to fit in correctly in checking fixture.
Examples
|
Part drop fiting in C/F. Part is fitting in C/F slots correctly.
|
Part not fitting correct in C/F. Part not fitting in slots
|
|
Profile angles correct and leg length within min and max in cut out.
|
Profile angles incorrect, leg length oversize not fitting within min and max in cut out.
|
|
Part fitting in C/F slots correctly. Leg length correct within min and max cut out length.
|
Part not fitting in C/F slots.
|
|
Angle profile correct
|
Angle profile not correctn not fitting in C/F slots.
|
| Edit Delete |
| 4 |
|
QUALITY INSPECTION
- The Last-off from the previous batch is to be compared to the current batch First-off. Last-off is to be placed in the production run.
- Complete a First-off before comencing with production, record on system Inspection no 6232
- First-off sample to be tagged and remain with the checking fixture.
- Conduct in-process inspections every hour and record on system Inspection no. 6233
- At the end of the batch, last part is to be tagged and kept with the checking fixture. First-off is to be placed in the production batch
| Edit Delete |
| 5 |
|
REJECTS
- All reject parts are to be placed immediatley in the red reject bins provided.
- All rejects should be logged on the system hourly. Reject Analysis.
Scrap / Reject bins are to be emptied at the end of end job or at the end of shift if the job is running at the end of shift
|
 |
| Edit Delete |
| 6 |
|
PERFORMANCE TARGETS
|
Once the job has been logged on the system, you will be able to see the production figures and targets including
- The Total Qty made against the job
- The quantity prodcued on the shift (day),
- The Std Time and the number of Parts required to be made per hour.
The picture to the left provides and example.
|
 |
Production figures are to be logged on the system every hour.
| Edit Delete |